Setting CLIPPER F parameter forces Clipper delimiting how many file handles may it use among of them.Ĭlipper executive itself uses up at least one handle (when beneath EXE there are OVL-s, or, EXE does have more than one overlay sections in it then more than one handles) so when you have a FILES value of 100 then the maximum of acceptable SET CLIPPER F values is 99.į value can be either even or odd, it does not make a difference. I dont see you using, I foreworn only.) By the way: FILES (or FILESHIGH, egal) serves memory places for DOS file handles. Remember: never use smartdrive if you have to run a Clipper application.

I have solved ii for now by rewritting the program so that it only opens the files it needs as it needs them. I was hoping to keep the Clipper summer of 87 running on windows 98. I am not a programmer but a gift shop owner who knows enough clipper to do some things. I have solved my problem by rewriting the program so it only opens what it needs as it needs it, but I would still like to figure out how to open more files at once. I think your V parameter is a bit on the low side and it may be helpful to add an R parameter to allocate more memory for indexing.

Ideally the f value should be 5 greater than the filehigh value and it should be an odd number. I tried rewriting the program so that it opens less files at the beginning and it works. Any other ideas I can rewrite the program so that it opens and closes files as it needs them and it will run but figuring out how to open them all at once will save me a lot of time. Clipper Summer 87 Software S How To Open Them I also tried allocating the memory in the properties of the DOS session. Make sure in the properties of your MSDOS session that you allocate as least 2 meg of this.ĭont mess with the memory until you try the settting changes first). Try taking the HIGH of of files in your config.sys file FILES100 Then change your SET CLIPPER to SET CLIPPERF99 V11 (the command we used for a long time).Īnother thing is that the older versions of clipper used expanded memory, I believe. The F55 part of the clipper command is the max file handles that clipper will handle. If that is about where yu are failing then you need to check the two things gheath gave you before. It will compile and it will run a small program with a few files open but it will not run a program that opens several files.

Clipper Summer 87 Software S Driver From WithĬlipper Summer 87 Software S Driver From With.

Clipper Summer 87 Software S How To Open Them.

Clipper summer 87 software